There 3 PCS processes for roll forming of rim, 3 times, so need 3 sets machines

Rotary roll forming is a cold forming process where profiles are formed in straight side cylinders or rings, The blanks is roll-formed between upper and lower dies which are mounted on two horizontal spindles. The rim profile is gradually formed while the dies and the blank are rotated
At the same time, guided along side guide roll. This roll formers is employing hydraulic motor driving system which allows the automatic speed coincidence and ideal torque distribution between upper and lower dies. The rim profile is formed by three steps. A loader/un-loader is incorporated to facilitate the blank handing.

Parameters:
Rim diameter: 17"~ 38"
Rim width: 4"~ 17"( expand width: 600mm)
Rim thickness: 3mm ~ 6mm
Rate of production: ≥ 3 pieces per minute
Upper Roll Axle Diameter: φ 200
Down Roll Axle Diameter: φ 200
Central Space between Two Axles: 320mm ~ 570mm
Rolling Pressure: About 400KN(16Mpa)
Type of drive: Hydraulic
Electrical system: PLC
Double spindle synchronous device
Cooling system, Lubrication system
Spindle Speed (nominal): 130 rpm
Output Torqure per Spindle: 4000N. M
Total Power: 130Kw